This Paper presents the basic concept and methodology variable levels of DC voltage as well as reversal of polarity (without changing terminals physically). The circuit has been designed for this purpose can break into two parts: Dual H-bridge Converter and Microcontroller. Dual H-bridge converter is available in the form of L293D IC and L298N.The total power loss of existing system i.e. 8051 microcontroller with L293D was 1.7365W. While the total power loss of PIC microcontroller with L293D was1.56165W So, We have chosen proposed Atmega328 I.C because the power loss has been reduced to 1.560115w. The Microcontroller Atmega328is programmed with C++ language. The Atmega328 microcontroller provides pulses to the gate of the NPN and PNP transistor for the required output DC voltage and polarity, which runs the DC motor.
Ubaid Hussain Sohail Gul Dr. Muhammad Naeem Arbaab and Amjad Khan Speed and Direction Control of a DC Motor using Dual Converter Technique International Journal of Engineering Works Vol. 6 Issue 04 PP. 120-125 April 2019
Asha K R, SuhadaTasleemP“RealS Time Speed Control of a DC motor by Temperature Variation using LabVIEW and Arduino” 2017 International Conference on Recent Advances in Electronics and Communication Technology, 16-17 March 2017
Mario Gavran*, MatoFruk** and GoranVujisić“ PI controller for DC motor speed realized with Arduino and Simulink” 22-26 May 2017
L.Boaz1, S.Priyatharshini2“DC Motor Direction and Speed Control byArduino through RF Wireless Technique” International Journal of Innovative Research in Computerand Communication Engineering ,Vol. 4, Special Issue 2, April 2016.
Lei Zhao, ChuangyuXu, XuemeiZheng and Haoyu Li “A Dual Half-Bridge Converter with Adaptive EnergyStorage to Achieve ZVS over Full Range ofOperation Conditions” Energies Article, 28 March 2017.
ShashiBhushan Kumar, Mohammed Hasmat Ali*, AnshuSinha, “Design and Simulation of Speed Control of DC Motor by Artificial Neural Network Technique” International Journal of Scientific and Research Publications, Volume 4, Issue 7, July 2014.
Oun Lee, Shin-Young Cho, and Gun-Woo Moon “Phase-Shifted Dual H-Bridge Converter with a Wide ZVS Rangeand Reduced Output Filter” IEEE, 2012.
Zhe Zhang and Michael A. E. Andersen“Interleaved Boost-Half-Bridge Dual–Input DC-DCConverter with a PWM plus Phase-Shift Control forFuel Cell Applications” IECON, IEEE, 2013.
WasanPhetphimoon “Modeling and Simulation of Bidirectional Half Bridge DC-DC Converter” ELEKTRO, IEEE, 2016
G.SUDHA1, “Performance Based Comparison Between Various Z-N Tuninng PID And Fuzzy Logic PID Controller In Position Control System Of Dc”, International Journal on Soft Computing (IJSC) Vol.3, No.3, August 2012.
Manoj Kushwah1 and Prof. Ashis Patra2, “Tuning PID Controller for Speed Control of DC Motor Using Soft Computing Techniques-A Review” Advance in Electronic and Electric Engineering, Volume 4, Number 2 (2014), pp. 141-148.
J. C. Basilio and S. R. Matos, “Design of PI and PID Controllers With Transient Performance Specification”,,” IEEE Trans. Education, vol. 45, Issue No. 4, 2002, pp. 364- 370
AdityaPratap Singh, “Speed Control of DC Motor using PID Controller Based on Matlab” International Conference on Recent Trends in Applied Sciences with Engineering Applications, Vol.4, No.6, 2013.
Rahul Malhotra1, Narinder Singh2, Yaduvir Singh3, “SOFT COMPUTING TECHNIQUES FOR PROCESS CONTROL APPLICATIONS” International Journal on Soft Computing (IJSC), Vol.2, No.3, August 2011.
MdAkram Ahmad, PankajRai, “Speed control of a DC motor using Controllers” Automation, Control and Intelligent Systems,2014; 2(6-1): 1-9
Ramesh Chandra Chourasia, Mukesh Kumar, “Speed Control of S.E.D.C. Motor by Using Pi and Fuzzy Logic Controller” International Journal of Soft Computing and Engineering (IJSCE),Volume-3, Issue-2, May 2013.
J. C. Basilio and S. R. Matos,“Design of PI and PID Controllers With Transient Performance Specification”, ,” IEEE Trans. Education, vol. 45, Issue No. 4, 2002, pp. 364- 370.
ShashiBhushan Kumar, Mohammed Hasmat Ali*, AnshuSinha, “Design and Simulation of Speed Control ofDC Motor by Artificial Neural Network Technique” International Journal of Scientific and Research Publications, Volume 4, Issue 7, July 2014.
KapinjayUcharia, Himmat Singh, “International Journal of Scientific Engineering and Technology” Volume No.3 Issue No.3, pp : 235 – 239 1 March 2014.
AdityaPratap Singh, “Speed Control of DC Motor using Pid Controller Based on Matlab” Innovative Systems Design and Engineering, Vol.4, No.6, 2013 - Selected from International Conference on Recent Trends in Applied Sciences with Engineering Applications.
P. M. Meshram, Rohit G. Kanojiya “Tuning of PID Controller using Ziegler-Nichols Method for Speed Control of DC Motor” IEEE- International Conference On Advances In Engineering, Science And Management (ICAESM -2012) March 30, 31,2012 117.
Copyright KWP Journals
All articles are licensed under a Creative Commons Attribution 4.0 International License.
